40
ERDC/CRREL SR-02-1
Figure 19. The 6-foot Henderson spreader was mounted on the M100 trailer
at the request of commanders in Kosovo. Efforts were made to try to
discourage this arrangement because of safety issues. However, the unit
insisted, and four of these were made up and shipped. All four suffered
accidents--one turned over and took the HMMVW with it. Spreaders should
never be mounted in trailers.
12. Check the spreader before performing any operations to ensure that all
shields and grates are properly installed.
13. The drive shafts, conveyor (belt), and spinner assemblies transmit
considerable amounts of power and are extremely hazardous when operating.
Perform all maintenance, inspections, and operator adjustments with the power
off.
14. When operating the vehicle with the spreader, keep clear of personnel,
equipment, and property. Be considerate of people standing along the edge of the
road.
15. Use tire chains at all times when conducting sanding operations on icy
roads. Chains enhance vehicle control and provide an added measure of safety.
This is especially true on roads with grades and curves.
16. Do not leave spreader running while unattended. Completely disengage
spreader, stop engine, shut down truck engine, and secure vehicle.
Previous Page
