Snow and Ice Control
39
3. Be aware that slower is always better than faster; not only is it safer,
but the sanding pattern is more effective. The maximum effective speed when
sanding is 15 mph; however, the ideal speed is 12 mph or less. If plowing snow
at the same time, the maximum allowable speed is 10 mph.
4. Be constantly alert to the area being sanded and the possibility that an
insufficient amount of sand is being spread over the desired area. More sand may
be necessary on steep inclines and at intersections. This can be accomplished by
slowing vehicle speed to 67 mph.
5. Be alert to all conditions and adjust sanding operations accordingly.
Limited visibility, severe road conditions, and difficult road surfaces require a
slower speed for sanding operations. When in doubt, go slower. Be aware that
spreader operations at speeds greater than 1012 mph may not be appropriate for
conditions.
6. Ensure that all persons are clear from the vehicle with sand spreader and
when conducting sanding operations. If in doubt, stop and check the area and
ascertain that the area is safe for sanding operations.
7. Try to keep the sand as dry as possible. However, if it is damp and is put
into the hopper that has the grate installed, and the sand goes through the grate, it
will spread sufficiently.
8. Shut off all power before allowing anyone to work on the spreader.
9. Do not conduct sanding operations on a side hill and do not attempt
sharp turns on an incline. The possibility of tipping over is very great. Do not
mount a spreader in a trailer.
10. Anyone who installs, mounts, or services spreading equipment must be
properly instructed and provided with applicable warnings.
11. Follow and adhere to all decal instructions, cautions, and warnings.
Previous Page
