12
ERDC/CRREL SR-02-1
CAUTION: Too much downward pressure can cause loss of steering
control.
5. Use tire chains at all times when plowing. The use of chains enhances
control and provides added safety. Also, check to ensure that tires are mounted
with tread in the proper direction.
6. When traveling over roads with the plow up and not in use, install the
safety bar to prevent accidental drop.
7. Keep in mind the following safety tips:
(a) Slower is better than faster.
(b) When plowing a right-turn curve there are conditions that could force
your vehicle to the left into oncoming traffic; when plowing a left curve and
pushing snow to the left, certain conditions can force your vehicle to the right.
These conditions include attempting to plow at high speeds, attempting to plow
too much snow, icy surfaces, and a curb higher than the trip-edge.
8. If there appears to be too much snow, slow down and raise the blade; a
second or third pass may be necessary to achieve a clean surface.
9. If the surface is icy, use chains on all four wheels. Also, ensure that tire
pressure does not exceed the maximum recommended by TACOM (40 psi).
Under no circumstances should tire pressure be greater than the recommended 40
psi.
10. If tire slippage occurs because of deep snowplowing where the blade is
slightly raised and 48 inches of snow remain on the road, lower tire pressure to
26 psi for added traction.
WARNING!
Do not drive the SEE over 15 mph with tire pressure of 26 psi, even for short
distances.
11. Maximum recommended plowing speed on hard-surfaced roads is 12
mph; on secondary gravel or dirt roads, maximum recommended speed is 10
mph. When plowing landing sites or open field areas, 5 mph or less is the
recommended speed. If in doubt in any situation, SLOW DOWN.
12. Be constantly alert to the area being plowed and to possible obstructions
beneath the snow. If in doubt whether a curb or other obstacle is too high, raise
the blade or steer around the obstacle, or both. If the obstruction is unknown, stop
and investigate before proceeding.